Remote-processing RPC-330 Manuel d'utilisateur télécharger pdf (Page 13)

SAVING PROGRAMS SECTION 3

Page 3-3 RPC-330

To change the EPRO M in U6, remove the IC and

replace it with the new one. When installing a 29C256,

pin 1 on the IC goes into socket pin 3. The top two

rows of pins are empty.

ALTERNATE EPROMS

Flash EPROMs are more expensive than UV er asable or

OTPs as of this writing. Large volume OEM' s may

wish to use lower cost EPRO Ms.

Program development must use flash EPROM s. When a

program is finished, the flash EP ROM may be used as a

master. Use an external program to duplicate progr ams.

Jumper W3 is normally configured for flash EPROM

(W3[3-5] and W3[4-6]). For non-flash EPRO Ms, W3 is

configured for [1-3] and [2-4]. Large volume OEM's

should contact Remote Processing regarding pre-

configuring W2 and W3 for your application.

COMMANDS

The following is a list of RPBASIC-52 commands used

for saving, loading, and executing programs and data.

These commands and functions are explained in the

Software Supplement in this manual.

Command Function

BLOAD Transfers binary data from

EPROM to RAM

BSAVE Transfers binary data from RAM

to flash EPROM

EXECUTE Loads, clears memory, then runs

a program from within a program

LOAD n Loads a program from EPROM

SAVE n Saves a program to flash EPROM

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 47 48

Pas de commentaire

Remote-processing RPC-330 Manuel d'utilisateur Page 13