Remote-processing RPC-330 Manuel d'utilisateur télécharger pdf (Page 27)

DIGITAL I/O SECTION 6

Page 6-6 RPC-330

Figure 6-3 Digital I/O connector pin out (viewed from top)

Table 6-1 Connector pin ou t - J3

Pin # 82C55 Description Opto

Channel

19 Port A, line 0 8

21 Port A, line 1 9

23 Port A, line 2 10

25 Port A, line 3 11

24 Port A, line 4 12

22 Port A, line 5 13

20 Port A, line 6 14

18 Port A, line 7 15

10 Port B, line 0 High current 16

8 Port B, line 1 High current 17

4 Port B, line 2 High current 18

6 Port B, line 3 High current 19

1 Port B, line 4 High current 20

3 Port B, line 5 High current 21

5 Port B, line 6 High current 22

7 Port B, line 7 High current 23

13 Port C, line 0 Lower C 0

16 Port C, line 1 Lower C 1

15 Port C, line 2 Lower C 2

17 Port C, line 3 Lower C 3

14 Port C, line 4 Upper C 4

11 Port C, line 5 Upper C 5

12 Port C, line 6 Upper C 6

9 Port C, line 7 Upper C 7

26 Ground

2 +5V

COMMANDS

The following tables shows the RPBASIC-52 commands

used for digital I/O.

Command Function

CONFIG LINE Configures I/O por ts.

COUNT Returns number of pulses at a line.

LINE Function returns status of an opto

module as a 0 or 1.

LINE Statement turns on or off an opto

module.

LINE B Function returns 8 data bits from

any I/O type device.

LINE B Statement writes 8 data bits to any

I/O type device.

LINE # Function returns status of line at

J3 connector as a 0 or 1.

LINE # Statement writes data to a line at

J3 connector as a 0 or 1.

ON COUNT Counts pulses and optionally

generates an interr upt.

ON LINE Generates an interrupt when a line

changes

PWM Sets PWM parameters for any

line.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 47 48

Commentaires sur ces manuels

Pas de commentaire

Remote-processing RPC-330 Manuel d'utilisateur Page 27

Commentaires sur ces manuels

Produits connexes et manuels pour Ordinateurs Remote-processing RPC-330